2000 Toyota Celica GT -S L4-1762cc 1.8L DOHC MFI Removal and Installation
Download FOR VEHICLES EQUIPPED WITH A CATALV`|1C CONVERTER CAUTION: ll large amount of unbumed gasoline flows Into the converter, It may overheat and create a flre haz- ard. To prevent this, observe...
View ArticleKawasaki ZX-10 R MXL Strada / Pista Plug and Play kit Isntallation Manual
download INSTALLATION STEP # 1 – Removing front transparent fairing and mirrors. The first installation step consists in removing the bike front transparent fairing and the lateral mirrors. The front...
View ArticleHarley Davidson Softail Drive Side Brake System Installation Manual
download Removing The Stock Components Although the PM Drive Side Brake System can be installed with the swing arm bolted to the frame, we recommend removing it for better access as well as repainting....
View ArticleHONDA TRX 400EX Removing Stock Carb and Cables INSTRUCTION
download Remove seat/fender assembly and fuel tank. 2. Remove throttle cables paying close attention to routing. 3. Remove thumb throttle housing if you are installing a twist throttle. 4. Remove air...
View Article1996-2004 HONDA XR250R Removing stock carburetor and cables
download Install the throttle cables into the supplied throttle housing and place onto clean handlebar end. 2. Remove the rubber carburetor alignment tabs from the manifold using a razor blade or sharp...
View ArticleYAMAHA RAPTOR 350 Removing stock carburetor and cables
download remove seat and gas tank. Make sure fuel petcock is in “off” position. 2. Remove throttle cable paying close attention to routing, as the new cable (s) will need too be routed the same. 3....
View ArticleBajaj Removing And refitting Automatic Cam Chain Tensioner
download 1. Remove the 2 Flanged Bolts securing the Tensioner Assembly. 2. Remove Tensioner Assembly from the engine block. 3. Unscrew and remove Lock Bolt. 4. Remove Pushrod, Ball & Retainer,...
View ArticleYAMAHA YFM 350 Removing stock carburetor and cables.
download Remove seat and gas tank. Make sure fuel petcock is in “off” position. 2. Remove throttle cable paying close attention to routing, as the new cable (s) will need too be routed the same. 3....
View ArticleTriumph Bonneville America And Speedmaster The Freak Installation...
download INSTALLATION In order to install The Freak, the factory air-box must be removed. Because of it’s design, the factory air-box is not an item that is easily removed. There are several parts that...
View ArticleHARLEY DAVIDSON AUXILIARY BRAKE/RUN/TURN SIGNAL CONVERTER KIT INSTALLATION...
download INSTALLATION To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) Disconnect negative (-)...
View Article